Entering mixer data
Entering mixer data
|
<< Click to Display Table of Contents >>
|
  
|
Quick start basics - Building a GSP model .
| 1. | Open the mixer data form and select the General tab sheet. |
 |
In this tab sheet the mixer entry area is specified, either separately for duct and core entry, or combined as total entry area with a specific static pressure ratio.
| 2. | Select the Specify total area, static press. ratio radiobutton. |
| 3. | Set the Total entry area to 0.61. |
| 4. | Set the Stat. Press. ratio to 1. |
The static pressures for duct and core are matched.
| 5. | Select the Output tab sheet and check the output variables desired. |
| 6. | Click OK to close the mixer component data form. |