Quick start basics - Building a GSP model .
| 1. | Open the low pressure turbine data form. |
| 2. | Select the General tab sheet and check if the shaft nr./suffix is set to 1. |
Now the low pressure turbine is linked to the fan.
| 3. | Select the Design tab sheet and set the design rotational speed to 10000 rpm at 100%, equal to the fan rotational speed. |
| 4. | Select the Map tab sheet and browse for a map 'turbimap.map' to embed the map file by setting the storage location to Local. |
| 5. | Select the Output tab sheet and check the output variables desired. |
| 6. | Change the NGV station label (on the Output tab) from 41 to 47 to prevent station label duplication. |
| 7. | Click OK to close the high pressure turbine component data form. |
Entering LP turbine data
