Error:
6104 - A transient calculation is not allowed if the control fully trimmed steady state option is checked
Cause:
The control fully trimmed steady state option is checked in the control's Schedules tab sheet.
Action:
Uncheck the fully trimmed steady state option in the Schedules tab sheet.
Background:
When the option is checked, the steady state point determined is the actual fully trimmed steady state point with the effect of the control's integrator in time. This option therefore includes both the determination of the (untrimmed) steady state point as well as the transient run required to reach the fully trimmed situation.
Normally, a steady state point does not coincide with the fully trimmed steady state point if a control is present. Instead, the fully trimmed point must be achieved by running a transient until the engine is stabilized.
Controls specific errors
