gsphelp  Turbine specific errors

<< Click to Display Table of Contents >>

Navigation:  Errors > Component specific errors >

gsphelp  Turbine specific errors

Previous pageReturn to chapter overviewNext page

The following turbine specific errors can occur:

 

5601 - Shaftnr. number in component already driven by turbine

5602 - Free Power shaft nr. number already defined in component. Must be new shaft !

5603 - Undefined shaft nr. number in component must be free power shaft

5604 - User specified/Externally controlled speed shaft nr. number in component must either be free power shaft or drive compressor with user spec./extern.controlled speed

5605 - Design point shaft power absorbed cannot be 0 in component

5606 - No shaft nr. or suffix specified in component