gsphelp  Running a new model configuration

<< Click to Display Table of Contents >>

Navigation:  Quick Start Basics > Building a GSP engine model >

gsphelp  Running a new model configuration

Previous pageReturn to chapter overviewNext page

Quick start basics - Building a GSP model .

 

With the new built GSP model configuration simulations can now be run. Before a simulation is run the validity of the model configuration and component data is checked during the Design point calculation. If the model is invalid, the calculation is canceled and an error is reported (for possible errors see error messages). If the design point calculation succeeds, the model is valid and steady state, steady state series and transient simulations can be run as explained in "Your first simulation session".

 

The project should look similar to the figure below.

 

GSP11ExampleProjectTJETend